Form D for China-Made Goods Shipped From Singapore

Updated: 6 days ago

Can you use Form D for China-made goods bought from a Singapore supplier? No, not on its own. Form D shows that goods originate in an ASEAN country. It does not follow the shop you bought from, the port the goods were loaded at, or the company that sends the invoice. If a Singapore supplier resells goods made in China, the origin certificate to ask about is a Form E, not a Form D.
Updated 31 October 2026 · By IFG Shipping
It is easy to read "supplier in Singapore, shipped from Singapore" and assume the goods are Singaporean for duty purposes. A trader's question quoted in our Bahasa Indonesia Form D guide shows the confusion: "The goods which are made in China will come into Singapore first before being exported out to Malaysia. Can the shipper still apply for Form D?" The short answer is in the tests below, and they are less about the shipment than about where the goods were made.
What Form D actually tests
Form D is the certificate of origin under ATIGA, the ASEAN Trade in Goods Agreement. Article 26 of ATIGA counts a good as originating when it was grown, made or otherwise produced entirely in the exporting Member State, or when it falls short of that but qualifies under Article 28 or Article 30. Article 28 gives two ways to qualify: a regional value content of not less than 40%, or a change in tariff classification at four-digit level for all non-originating materials. The exporter chooses which test to use.
That is the whole origin test. Everything else on your paperwork is a different question.
What you can see | Does it set origin? | What ATIGA does with it |
Where you bought the goods | No | Not one of the tests above. Origin turns on where the goods were made or produced. |
The loading port | No | Article 32 is a separate route test: preferential treatment applies to goods consigned directly between the exporting and importing Member States. A good route cannot create origin. |
The company that invoices | No | Rule 23 lets a company in a third country invoice, provided the goods meet the origin rules (see below). |
Packing, storing or loading in Singapore | No | Article 31 lists preserving goods for transport or storage, facilitating shipment and packaging them for sale as minimal operations that are not counted. |
Where the goods were made or changed | Yes | Wholly obtained, 40% regional value content, or a change of tariff heading. |
The tariff-heading test needs the right code, so check your HS code before you rely on it.
Case 1: China-made goods you only bought and resold
Say the goods were made in China, a Singapore company imported them, and you now buy them and ship them to Malaysia or Indonesia without any change. Form D cannot cover that. MITI Malaysia states that ATIGA is only for ASEAN Member States. A back-to-back Form D, used to re-export ASEAN goods through Singapore, also needs a valid original Form D to be presented. Goods that began in China have no Form D to present.
The ASEAN-China agreement (ACFTA) and its certificate, Form E, are the ones that fit this lane. Singapore Customs issues a back-to-back ACFTA Form E (certificate type 20) for a re-export. The conditions include:
The agreement must cover both China and the country the goods are finally going to, with Singapore in the middle.
The import into Singapore is covered by a preferential certificate issued in China.
The goods are not processed any further while they are in Singapore.
The supporting documents include the original certificate from China, the exporter's invoice and an import permit.
The application is made by the Singapore re-exporter, which is usually your supplier, not you. On the importing side, Royal Malaysian Customs lists Form E as the proof of origin for ACFTA, and Indonesian Customs lists e-Form E among its electronic schemes. For the duty mechanics, read our Form E guide. If you plan to import from China into Malaysia directly, see importing from China to Malaysia.
Case 2: goods made or changed in an ASEAN country
Made in Singapore. Singapore Customs sets out three steps for locally manufactured goods: register the manufacturing premises or product line, submit a manufacturing cost statement for verification against the origin criteria, then apply for the certificate with the export permit through TradeNet. That route is built around a manufacturer, so a trading company should not expect it to cover goods it only buys and sells.
Made elsewhere in ASEAN, bought through Singapore. The Form D comes from the country that made the goods. Goods that start in one ASEAN country stay ASEAN-origin when they pass through a second member state, provided nothing beyond the minimal operations above was done to them. If it passes through Singapore, Singapore Customs can issue a back-to-back Form D (certificate type 17) against the original.
Third-country invoicing: another company invoices, origin stays put
Take the second question buyers ask: a factory in Malaysia ships direct to Indonesia, while a Singapore company invoices the buyer. Nothing here stops a Form D. Rule 23 of the ATIGA operating procedures obliges the importing country's authorities to accept a Form D even when the buyer's invoice comes from a company in a third country, or from an ASEAN exporter acting for that company, as long as the goods pass the origin rules.
What the exporter must do is declare it. The Form D overleaf notes say to tick the "Third Country Invoicing" box in box 13 and put the invoicing company's name and country in box 7. MITI confirms that third-party invoicing is allowed under ATIGA, and Indonesian Customs describes it as invoicing by a company in a third country, Member State or not, or in the same country that issued the certificate. Our ATIGA Form D guide counts an undeclared third-country invoice among the common rejection traps.
Note what the rule does not do. It accepts a different invoicer, but only for goods that already meet the origin chapter. A Singapore invoice does not turn Chinese goods into ASEAN goods. Indonesian buyers who also need the importer's name sorted should read our guide to the importer of record in Indonesia.
The evidence that proves origin in each case
Case | Document that fits | What sits behind it |
China-made, resold unchanged | Form E; from Singapore, a back-to-back Form E where the conditions are met | Original Form E from China, exporter's invoice, import permit |
Made in Singapore | Form D from Singapore Customs | Registered premises, manufacturing cost statement, TradeNet application |
Made in another ASEAN country, resold via Singapore | The original Form D, or a back-to-back Form D | Valid original Form D or its certified true copy |
ASEAN factory ships direct, another company invoices | Form D from the factory's country, with third-country invoicing declared | Boxes 7 and 13 completed; invoice matching the Form D |
Two further points apply in every case. Under Rules 5 and 6, the exporter applies with supporting documents proving the goods qualify, and the issuing authority checks that the other statements on the Form D correspond to those documents. So the invoice, packing list and Form D must tell the same story. And since 1 January 2024, importing Customs may reject a hardcopy Form D, because all ASEAN Member States have implemented full electronic transmission.
At the border, Royal Malaysian Customs asks the importer for the import declaration, the proof of origin and the supporting documents such as the invoice, bill of lading and packing list. Indonesian Customs says the importer must show that the goods come from a country named in the agreement. MITI warns there is no guarantee of preferential treatment, and if compliance is not proven the importing authority may suspend it and verify the goods.
When Form D does not apply
The goods are Chinese origin and were not made or changed in an ASEAN country. Look at Form E, or accept that no preference is available.
The goods were changed in Singapore only by the minimal operations in Article 31.
You hold only a hardcopy Form D, which the importing Customs may reject.
The invoice, Form D and packing list do not match.
Before you pay a Singapore supplier, ask five things. Where were the goods made? Do you hold the original certificate from the first exporter, and is it a Form E or a Form D? Will anything beyond storing, packing and loading happen to them in Singapore? Which company invoices, and is it in another country? And what is the HS code on the invoice? If the answers do not line up, expect to pay the normal duty rather than guess. For other routes, our certificate of origin guide, RCEP guide and Malaysian export guide set the options side by side, and the Bahasa Indonesia explainer Form D untuk negara mana saja covers the country list.
Send the shipment to IFG, or ask Iman first
Hand the shipment to IFG. IFG is a forwarder. Send IFG your shipment details or email IFG with the supplier's invoice, any certificate of origin you hold and where the goods are going. We will reply with which origin document fits the route.
Or ask Iman first. Iman Yusoff answers shipping questions for free on WhatsApp at +60 14 325 8325. Send one question with company names and prices removed. There is no course or certificate behind it.
This guide reflects the texts and customs pages as read on 31 October 2026. Customs authorities decide each claim, so confirm the current rule with the issuing and importing authority before you ship.
Content production support: SingRank, an SEO and AI search (GEO) agency in Singapore.




Comments