top of page

Shipping Equipment to a Malaysia Supply Base: Two Checks

Writer: Iman Yusoff
Iman Yusoff
Nov 11
10 min read

Updated: 6 days ago

Rows of blue cargo baskets and steel riser joints on the quay beside an anchor-handling tug, Malaysian offshore supply base in Labuan, overcast soft light
Illustrative image.

Your buyer says deliver to the supply base, so you book it like any other Malaysian port delivery. Nobody has asked what customs status that base holds, or which ship may carry each leg. When you are shipping equipment to a Malaysia supply base, the words "supply base" settle neither question.

The short answer: make two checks before you compare freight. First, the base's customs status, because a licensed petroleum supply base and a base on Labuan do not give the same duty answer. Then the rule on each sea leg, because sailing in from abroad and sailing out to a platform are treated differently.

For the wider route, see our guide to shipping from Singapore to Malaysia.

Which Customs Status Does Your Supply Base Have?

Ask for it in writing, because the name will not tell you. Under the Customs Act 1967 (reprint as at 1 June 2021), s.77A gives the definition: a petroleum supply base is an area holding a licence under s.77B. Section 77B(1) lets the Director General license a person to manage and administer one, and to carry out approved activities there.

So "petroleum supply base" is a licensed status, while "supply base" on a delivery instruction may just be a name. Here is what is on record for four bases, which is not a full list.

Base

What is on record

What that does not settle

Kemaman Supply Base

Its operator states that the Petroleum Supply Base scheme licence covers the whole base, and that imported oil field equipment entering and then going offshore has its taxes and duties deferred. The same page lists a Licensed Manufacturing Warehouse.

Which licence covers your cargo. The statement is about equipment going offshore, not equipment that stays onshore.

Asian Supply Base, Labuan

Its operator says it has operated since 1984. Customs lists a branch office there.

Whether the base holds a s.77B licence. A Customs office is not evidence of one.

Bintulu

The port authority states that since 1 September 2026 Bintulu has been a Sarawak state port, and that a licensed port operator runs the port.

The customs status of any supply base there. A port licence is not evidence of it.

Tok Bali, Kelantan

Customs lists a Tok Bali supply base office.

Whether the base holds a s.77B licence.

Kemaman shows why the name is not enough: one operator page, two licences. So ask the base operator which licence applies to the yard receiving your cargo, who holds it, and whether it covers what will happen to this equipment there.

Under s.77B(4), the licensee must supply a customs office and facilities, either inside the base or at its perimeter. If you are told a base is licensed, ask where that office is.

Ask Customs whether anything after that 2021 reprint changes your case.

What Deferred and Duty Free Really Mean

Neither term settles what you owe once the equipment moves on.

Deferred: the Kemaman operator's word

The word describes imported oil field equipment that enters the base and then goes offshore. Three sections of the Customs Act matter here:

  • Getting there, s.75(b). For transit to a petroleum supply base, dutiable goods can come out of customs control if they are already in such a base, an approved place, or a customs or licensed warehouse, under conditions the Director General sets.

  • Leaving after work is done, s.77C. If goods have undergone any process in the base, they cannot be released for home consumption or export unless the Director General approves first. Under s.77C(2), if those goods are released for home consumption, the duty is worked out as if they had been imported. That is subject to s.77E, under which duty may be remitted on waste or refuse from the process. Under s.77D, the Minister may, in a particular case and on conditions, exempt a person from part or all of that duty. That is case by case, so do not assume it.

  • Stock that runs short, s.77F. If a base comes up short on dutiable goods, the law presumes the owner of the goods or the occupier illegally removed them, unless they can prove otherwise, and they are liable for the duty on the missing goods. Under s.77F(2), the Director General may remit some or all of that duty if satisfied that unavoidable leakage, breakage or other accident caused the shortage. Keep your own count.

Section 77C speaks of processed goods. It does not tell you what unprocessed equipment pays on leaving a base. If you plan any work there, ask Customs whether it counts as a process, and what applies if it does not.

Duty free, on Labuan

Labuan's status comes from the island, whichever base you use. Section 155(1)(a) says no import duty is payable on goods imported into Labuan, other than goods declared by Gazette order. The current Labuan Order, P.U.(A) 385/2025, in force from 1 November 2025, levies duty only on cigarettes, tobacco product and smoking pipes. The Customs sales tax FAQ says imports into Labuan are exempt from sales tax, except for petroleum.

The trap is the next move. Under s.155, moving dutiable goods from Labuan to the principal customs area counts as importing them into Malaysia, so import duty is payable. Section 2 makes that area all of Malaysia except Labuan, Langkawi, Tioman, Pangkor and a free zone. So Sabah, Sarawak and the rest of the Peninsula count. The same FAQ calls that move a deemed import, subject to sales tax.

So tell whoever quotes you where the equipment goes after Labuan. If goods are already stuck, see our note on cargo held at Malaysian customs.

Will the Equipment Stay, Go Offshore or Come Back?

Settle this before you book, because each ending brings different paper. Write one of the three against every item.

Goes offshore. This is the ending the Kemaman statement describes. The sea leg falls under the vessel rules below.

Stays in Malaysia. This needs its own duty answer, which a status described for equipment going offshore does not give.

Comes back after the job. Temporary import relief exists, but do not assume it fits project work. Under s.97, the Director General decides whether to give relief, with re-export within 3 months or a further period allowed.

The Customs temporary import page, last updated 8 January 2026, lists research and demonstration, exhibitions, events, evaluation or test, and repair. Project or working use is not named, so get a written answer from Customs before you plan around it.

The same page sets conditions:

  • Goods must be re-exported within 3 months, with an extension the Customs station may approve for up to 12 more months, and any later one considered by Customs headquarters.

  • Renting, selling or transferring the goods needs the State Director's permission. If your equipment is on hire to whoever uses it offshore, raise that first.

  • The same goods must go back to the country of origin before the period ends. If the next job is elsewhere, ask Customs before you commit to it.

  • Private importers must give security equal to the duty and tax, by bank guarantee or bank draft. Customs can call it in if the goods are not re-exported in time.

Used drilling machinery and the 5-year rule

Check your item against MITI's heavy machinery list first. Mobile drillers and drilling derricks are on that Approved Permit (AP) list, and the heading carries a gross vehicle weight condition.

For listed machinery only, a normal import must be under 5 years from manufacture, with a Certificate of Origin. A temporary import licence allows machinery more than 5 years old, but only for legitimate domestic work. It is renewed every 6 months, and the machinery is re-exported once the project is over or the licence expires.

Bringing a crane or another machine? MITI lists several crane types and allows only new tower cranes, even on a temporary import, so read yours against the same list. MITI's licence and Customs' temporary import have separate conditions, so do not assume one stands in for the other. If the job has a return leg, read where MOB and DEMOB freight leaks money next.

Which Ship Can Carry Each Leg?

A foreign ship coming straight from abroad to one Malaysian port needs no Domestic Shipping Licence (DSL), says the 2023 eDSL FAQ. The 2024 notices and the 2026 Regulations do not restate that answer, so have the carrier confirm it for your vessel. Further Malaysian port calls, and the run from port to platform, are where the DSL comes in.

Malaysia's Cabotage Policy was implemented on 1 January 1980. The Ministry of Transport's FAQ says the DSL covers carriage between Malaysian ports and from Malaysia to the exclusive economic zone.

Sea leg

What the rule says

Source

Foreign port direct to one Malaysian port

The eDSL FAQ says a foreign-flagged vessel calling directly from a foreign port at one Malaysian port needs no DSL. MITI's undated glossary says a vessel from Singapore is free to make a direct call at any Malaysian port. That covers the direct call from abroad only: cabotage still applies between Malaysian ports, so a second Malaysian port call moves to the next row.

More than one Malaysian port

A DSL is required. Read this with the status quo notice below.

Peninsular Malaysia to and from Sabah, Sarawak or Labuan; within Sabah; within Sarawak

The cargo vessel exemption was revoked from 1 June 2024. Foreign containerised transhipment ships are exempted from the Cabotage Policy on routes between Peninsular Malaysia and Sabah or Labuan, and within Sabah, but a valid DSL is still required. Sarawak is not on that list.

Local cargo on a foreign ship, any port

Port authorities must ensure foreign registered ships carry import, export and containerised transhipment cargo only, and no local cargo. Local cargo by foreign ships is allowed for Sabah.

Port to platform in one state

A DSL is needed regardless of flag.

Foreign registered vessel on domestic work

Considered only where a Malaysian vessel cannot meet the demand. The 2026 Regulations carry a separate permitted ship application form for offshore ships.

  • Two 2024 notices. The 29 May notice requires a DSL for more than one port call. The later 10 September notice says that for all sectors, DSL implementation stays status quo as the industry practises it. It does not spell out that practice, so ask the carrier to state the licence position on your vessel and your route.

  • The old exemption. The 2017 exemption still appears in the eDSL FAQ that is online. The 29 May 2024 notice revoked it. The September status quo notice does not mention it, so do not accept a routing built on it without the carrier's written position.

  • Local cargo. The September notice does not say whether imported equipment relayed between Malaysian ports counts as local cargo, and its allowance names the state of Sabah only. Get that answered in writing for your cargo.

  • New Regulations. P.U.(A) 306/2026 came into operation on 1 September 2026, revoked the 1981 Regulations and defines a permitted non-Malaysian ship under s.68V. The eDSL guide, updated 29 September 2023, and the MOT FAQ use older section numbers than these Regulations cite, so do not rely on those numbers.

For general cargo port to port, see our guide to sea freight from Singapore to Sabah and Sarawak.

One Shipment, Four Stops: Customs, Base, Carrier, Road

Put a name against each stop. As an illustration, not a real job, take a pump skid from Singapore, on a foreign vessel calling one Malaysian port, into a base, out to a platform, then home.

Customs. K1 is the declaration of goods imported. K8 is the form for declaring a removal of goods in transit. Ask which one your movement uses, and which form covers the offshore movement. Nothing linked here settles who must be consignee and importer at a base, so get that answer in writing.

Base. Agree the yard space with the base. Because of the s.77F presumption, keep receiving and release records.

Carrier. The inbound vessel and the platform vessel sit on different rows of the table. For plain containerised spares calling one Malaysian port, ask about a liner service before a chartered vessel. Our note on moving critical spares when the asset is down covers the urgent version. For large pieces, see out-of-gauge cargo.

Road. If the skid leaves the base for an onshore site, it has changed ending, so raise that with Customs first. For a piece that starts by road from Singapore, see machinery on a low-bed truck to Malaysia. For an oversize piece, raise the road rules in your enquiry, with the dimensions and the route.

Six Checks Before You Book

Run these with any forwarder or the base operator, or with your base tenant or Malaysian consignee if it already handles import and vessel booking. IFG is one forwarder among many, so ask us the same.

  1. Status. Which customs licence applies to the yard receiving the cargo, and who confirms it in writing?

  2. Process. Will anything be done to the equipment in the base? If so, what does Customs say about s.77C?

  3. Ending. Does each item stay, go offshore or come back?

  4. Machinery. Is any item on MITI's heavy machinery list?

  5. Legs. What is the flag on every sea leg, and what is the DSL position on each?

  6. Names. Who handles clearance, storage, loading and road?

Send IFG the Shipment Details

Send us the equipment list, HS codes if you know them, the origin, which base and who receives it there, the final location after the base, weights and dimensions, and the ready date. Email contact@ifgshipping.com or WhatsApp +60 14 325 8325, or use our contact page.

IFG replies on the route and documents. Our IFG Shipping services page lists vessel chartering for oversized shipments, heavy lift transport for project cargo, MOB and DEMOB for oil and gas and offshore projects, and customs documentation and compliance. That list is not a statement that IFG holds a Domestic Shipping Licence, so the licence position on any vessel stays a question for its carrier, as in the Legs check above.

Frequently Asked Questions

Is equipment entering a supply base exempt from duty or only deferred?

Do not treat it as exempt. Kemaman's operator says deferred, and only for imported oil field equipment entering the base and then going offshore. Under s.77C(2) of the Customs Act, if processed goods are released for home consumption, the duty is worked out as if they had been imported, subject to s.77E. A s.77D exemption is case by case. For any other ending, ask Customs in writing.

Can equipment be temporarily imported and re-exported after the project?

Possibly, but do not assume it. Section 97 of the Customs Act leaves relief to the Director General's discretion, and the Customs facility page does not name project or working use. Ask Customs in writing first. Listed heavy machinery also has MITI's own temporary licence, for legitimate domestic work, renewed every 6 months.

Can a foreign vessel call directly at a Malaysian base?

A foreign-flagged vessel coming directly from a foreign port to one Malaysian port needs no DSL, says the eDSL FAQ updated on 29 September 2023. A second Malaysian port call changes that, so read the two 2024 notices above. Those rules speak of ports, so confirm with the base operator that it can take your vessel, and have the carrier state its licence position.

Does a vessel from the base to the platform need a DSL?

Yes, on the leg the eDSL FAQ describes: port to platform in one state, regardless of flag. The Ministry of Transport says the DSL covers carriage from Malaysia to the exclusive economic zone. The eDSL guide, updated 29 September 2023, says foreign registered vessels are considered only where a Malaysian vessel cannot meet the demand.

Customs and shipping rules change. This guide reflects the published texts linked above, as read on 7 November 2026. It is general information, not legal advice, and Customs decides every declaration. Confirm with Customs, the Ministry of Transport or the base operator before you ship.

Content production support: SingRank, an SEO and AI search (GEO) agency in Singapore.

Comments


bottom of page